Conduit bending calculators
Type what you measured and get the marks: offsets, saddles, rolling offsets, kicks, stub-ups, parallel runs and segmented sweeps. Every calculator uses the same engine as the BendMate app.
- Conduit Offset CalculatorEnter the offset height and bend angle to get the distance between bends and the shrink for an EMT, rigid or IMC conduit offset.
- 3-Point Saddle CalculatorWork out the three marks for a 3-point saddle over a pipe: the 45° center, the 22.5° outer bends, how far apart they sit and the shrink.
- 4-Point Saddle CalculatorGet the four marks for a 4-point saddle over a beam, duct or wide pipe from its height and width, plus the shrink for the angle you choose.
- Rolling Offset CalculatorEnter the rise and roll to get the true offset, the marks and the roll angle for a rolling offset that moves conduit up and sideways at once.
- Conduit Kick CalculatorFind where to mark a kick bend from the back of a 90, how much it moves the stub sideways, and the shrink, for any kick size and angle.
- 90 Degree Stub-Up CalculatorEnter the stub length and your bender’s deduct to get the mark for a 90 degree stub-up, with typical hand bender deducts for EMT sizes.
- Parallel Offset CalculatorWork out the offset marks and the shift per conduit for a bank of parallel conduit offsets so the spacing stays even through both bends.
- Segmented 90 CalculatorChoose the sweep radius and number of shots for a segmented 90 and get the degrees per shot and the spacing between marks.
- EMT Bending CalculatorCalculate EMT bends from 1/2" to 1-1/4": offset marks and shrink, 90 degree deducts by size, and which rule to use for each bend.
- Online Conduit Bending CalculatorA conduit bending calculator you can use in a browser: offsets, saddles and 90s, with the formulas it uses and how to check any answer yourself.